Page 1 of 1
Lookup Stage
Posted: Wed Oct 24, 2007 12:48 pm
by pravin1581
Hi All,
Is there any point in keeping Lookup Failure to Continue if Lookup Condition has been set to Fail. The latter condition will always abort the job if the lookup fails.Please enlighten me.
Thanks in advance.
Re: Lookup Stage
Posted: Wed Oct 24, 2007 12:52 pm
by Havoc
pravin1581 wrote:Hi All,
Is there any point in keeping Lookup Failure to Continue if Lookup Condition has been set to Fail. The latter condition will always abort the job if the lookup fails.Please enlighten me.
Thanks in advance.
How can you set the Lookup Stage to Fail and Continue at the same time?
Re: Lookup Stage
Posted: Wed Oct 24, 2007 1:15 pm
by pravin1581
Havoc wrote:pravin1581 wrote:Hi All,
Is there any point in keeping Lookup Failure to Continue if Lookup Condition has been set to Fail. The latter condition will always abort the job if the lookup fails.Please enlighten me.
Thanks in advance.
How can you set the Lookup Stage to Fail and Continue at the same time?
So fail and continue should not work together.
Re: Lookup Stage
Posted: Wed Oct 24, 2007 1:31 pm
by sri1dhar
pravin1581 wrote:Havoc wrote:pravin1581 wrote:Hi All,
Is there any point in keeping Lookup Failure to Continue if Lookup Condition has been set to Fail. The latter condition will always abort the job if the lookup fails.Please enlighten me.
Thanks in advance.
How can you set the Lookup Stage to Fail and Continue at the same time?
So fail and continue should not work together.
Yes, Once "Condition Not Met" is Failed the job aborts. It doesn't matter what you set for Lookup Failure