QualityStage standardize stage error

[abc123]

I have a simple job:

Dataset ---> Standardize ----> Dataset

I get the following error:

STD_Stage: Unable to open control file ./RT_QS156/V0S1/Controls/USADDR2_NAMESTD.DCT for input, reason code 2
No such file or directory

I had created a ruleset called USADDR2. I found the directory but another person can run this job fine.

[bobyon]

I have a simple job:

Dataset ---> Standardize ----> Dataset

I get the following error:

STD_Stage: Unable to open control file ./RT_QS156/V0S1/Controls/USADDR2_NAMESTD.DCT for input, reason code 2
No such file or directory

I had created a ruleset called USADDR2. I found the directory but another person can run this job fine.

I am having the same issue. Did you ever find a resolution?

Thanks,
Bob

[ray.wurlod]

After designing (or importing) the job, did you provision the server with the files it needs?

[bobyon]

I did run a Provision ALL on each of the standardization rules in the project before compiling all the jobs. Is that what you are asking or is there something else that needs to be done?

[JRodriguez]

Bobyon,

If you ran a "provision all" to this new rule and another person can run the job fine then take a look a permisions

You wrote:

"I had created a ruleset called USADDR2. I found the directory but another person can run this job fine"

[bobyon]

I went back and peformed all the steps again slowly and in order and things went fine. I must have gotten something out of order the first time. MIght have done the compiles before the provisioning.

At any rate, all is well now.

[bobyon]

I went back and peformed all the steps again slowly and in order and things went fine. I must have gotten something out of order the first time. MIght have done the compiles before the provisioning.

At any rate, all is well now.