DSXchange

Posted: **Tue May 08, 2007 1:07 pm**

Hi All,

The jobs has sucessfully finished and we could see the log in director saying it imported x rows from the seq file. but in designer was not able to see any link count in the perfomance statistics.

Please suggest some suggestions on this.

thanks in advance

Posted: **Tue May 08, 2007 1:50 pm**

Did you save or compile the job after you run?

Posted: **Tue May 08, 2007 2:51 pm**

No i didnt do that.

thanks

Posted: **Tue May 08, 2007 4:14 pm**

Check whether APT_NO_JOBMON has been set.

Posted: **Tue May 08, 2007 5:09 pm**

Or even whether the job monitor application (JobMonApp) is running.

Posted: **Tue May 08, 2007 6:15 pm**

Or that it didn't reject all the rows due to metadata mismatch. You got a reject link on that sequential file stage?

Posted: **Wed May 09, 2007 2:36 pm**

Open job in Designer.
On Job canvas right click. Is "show perfomance statistics" checked.
If not check it and it should show link counts.

Hope it helps...

DSXchange

Not showing up link count

Not showing up link count