Page 1 of 1
my parallel job is aborting
Posted: Fri Mar 02, 2007 10:17 am
by bollinenik
Hi,
I am doing hash partitioning in sortstage and it is gioiving below problem.
APT_CombinedOperatorController(2),0: sh: dbx: not found
Posted: Fri Mar 02, 2007 10:30 am
by DSguru2B
Search on the error message. I believe its been covered here before.
Posted: Fri Mar 02, 2007 10:58 am
by bollinenik
yes.....I did that but there is no exact solution, just some discussions are happened earlier.......that's why I posted if have any idea pls share with me
Thanks in Advance
Posted: Fri Mar 02, 2007 11:02 am
by DSguru2B
Are you getting any additional warning messages. Reset the job and see if you get any messages "From Previour Run".
Posted: Fri Mar 02, 2007 11:06 am
by bollinenik
yes.....I tried that also and I deleted that code and exported again still it's giving same problem