DSXchange

Hi DS Folks,
i am facing a very strange issue. The sequencer is not recognizing the jobs when it is under 2 levels down

Say we have the following structure:-

Sequencer is

Job
P1
M1

the sequencer doesnt recognize M1 folder . it recognizes till M1 [meaning, when jobs lie under till p1. it`shows M1 under P1 though. but M1 is not navigable].Is it a known issue???.

BTW , the version is 7.5x2


Wish to hear from you guys of any resolutions.

regards,
Prabu

Never worked on 7.5.x2. But is this happening in the Job Activity? Meaning - are you not able to see the job in this activity?

Doesnt seem to be an issue in 7.5.1 - as I can see such jobs in the Job Activity.

Aneesh

thebird wrote: But is this happening in the Job Activity? Meaning - are you not able to see the job in this activity?


Aneesh

that's true

Is your operating system Windows XP Pro with service pack 2 and, if so, do you have the DataStage patch for this combination installed?

ray.wurlod wrote:Is your operating system Windows XP Pro with service pack 2 and, if so, do you have the DataStage patch for this combination installed? ...

Yes Ray, its XP pro and service pack 2 , not sure about the patch. How should i check for the installed patches for DataStage

thanks

regards,
prabu