DSXchange

Hi all,

I am trying to use change capture in my job,i have connected two datasets to change capture and one dataset as output but the problem is i am gettin an warning like this can u just give me a solution

Warnning Message: Change_Capture_11: When checking operator: Defaulting "AccountType" in transfer from "beforeRec" to "outputRec".


Please respond to this.......


Regards,
N.Magesh

Hi,

In change capture stage properties, under output - columns tab,uncheck 'run time column propagation' and try running again.

hi tejaswini , just want to know i am using PX 7.5.2 i dont find RCP option in CDC stage in output tab --> columns .is it not present for my version?

It (RPC) may be disabled for the entire project which, to my mind, is a Good Thing.

The error message (which you only posted part of) suggests incomplete mapping to the output link. Go there, and check the Mapping tab.

Hi,

Disable RCP option at the job level in the property tab. Where you can find option called Enable runtime column propogation for new links. Don't select that option that means nothing but Disabled.

where can we find the option to enable/disable RCP i dont find in CDC stage can any one please help me out

Thanks

samsuf2002 wrote:where can we find the option to enable/disable RCP i dont find in CDC stage can any one please help me out

Thanks

Hi,

You can find the Run time column propogation at the stage level also, In Change Capture stage-go to the output tab and then go to the Columns tab, in that tab see below the cloumns at the left corner, where you can find the Runtime column propogation, if you want enable select the box and disable don't select the box. Default is enable.

Note that if RCP is disabled at a Project level, then you wouldnt find this option at the output tab of any of the stages.

If this need to enabled at a project level, it would have to be done from the Administrator.

The Bird.