Guys,
When I "Generate Report" for any job. The reports does not show column names. Its showing a table where column names are blank for stages but it shows associated datastye for same. Other properties are seen fine. Is there any setting we need to do for same.
regards,
santosh
"Generate Report" option error
Moderators: chulett, rschirm, roy
-
ray.wurlod
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
Do you design your jobs by Load of column definitions from previously imported Table Definition, or by just putting column definitions into job designs by hand? If the latter, there is no linkage back to a table definition in the Repository.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.