Page 2 of 2
Posted: Wed Aug 28, 2013 10:00 pm
by chulett
ps. Here is the
TechNote for the issue and APT environment variable in question.
Posted: Wed Aug 28, 2013 11:08 pm
by SURA
IBM asked me to do 3 steps and out of 3 I already did 2 (one is your suggestion of the APT) and i have mentioned it here.
Code: Select all
Check if the quoted ID is enabled for the problem DSN, if so disable it and run the job again.
I tried it, but no luck.
I am going to share my log details and based on their reply!
Posted: Thu Aug 29, 2013 12:36 am
by SURA
H i craig
Your suggestions was the right one. I declared it for the job level rather than the project level was the issue. If i could did it properly at the time when you given that APT, I could have resolved it.
IBM guy noticed my mistake and asked me to declare it globally.
Now the issue is resolved.
Code: Select all
As Craig said, add this variable $APT_OSL_PARAM_ESC_SQUOTE in the project level and use it in the job by passing the value as 1
Thanks to all for your time and suggestion.
Posted: Thu Aug 29, 2013 7:04 am
by chulett
Sweet! Thanks for the clarification, I would have thought having it at the job level would have been fine as well. Good to know.
Posted: Thu Aug 29, 2013 6:01 pm
by SURA
chulett wrote:I would have thought having it at the job level would have been fine as well. Good to know.
I was also in the same thought is the another reason why i declared it in job level.
thanks