Hi All,
Datastage 11.3 client is installed on Windows 7 enterprise edition desktop. It is a 32-bit OS. I am trying to open transformer inside a job and it is not showing up
I am trying to open director client. It is throwing the below error.
Run-time error '339':
Component 'MSCOMCTL.OCX' or one of its dependencies not correctly registered. a file is missing or invalid.
Please help!
Could not open transformer in 11.3
Moderators: chulett, rschirm, roy
Could not open transformer in 11.3
Thanks,
Sai
Sai
-
- Premium Member
- Posts: 1735
- Joined: Thu Mar 01, 2007 5:44 am
- Location: Troy, MI
you may need to re-register the OCX mentioned in the error. Else do a clean install after un-installing and deleting the relevant registry entries.
You can refer the step (not for the same issue) here
You can refer the step (not for the same issue) here
Priyadarshi Kunal
Genius may have its limitations, but stupidity is not thus handicapped.
Genius may have its limitations, but stupidity is not thus handicapped.
Please review the System Requirements.
The 11.3 and higher clients are only supported on 64-bit editions of Windows. They normally error during the install if a 32-bit OS is detected and will not proceed to install, at least that's what originally happened to us; not sure how you got past that...
The 11.3 and higher clients are only supported on 64-bit editions of Windows. They normally error during the install if a 32-bit OS is detected and will not proceed to install, at least that's what originally happened to us; not sure how you got past that...
Choose a job you love, and you will never have to work a day in your life. - Confucius