Checksum error
Moderators: chulett, rschirm, roy
Checksum error
I just ran into the same problem as noted here and not sure what stage in my job caused this error. Could you show me how to disable operation combination? Thanks.
APT_CombinedOperatorController(0),0: Failure during execution of operator logic. (shown few times)
APT_CombinedOperatorController(0),0: Internal Error: (!exportLog_->hasError()): checksum/checksum.C: 391
Traceback: Could not obtain stack trace; check that 'dbx' and 'sed' are installed and on your PATH
JnPocLocHierSK.LnChecksum_Sort,1: Failure during execution of operator logic.
APT_CombinedOperatorController(0),0: Internal Error: (!exportLog_->hasError()): checksum/checksum.C: 391
Traceback: Could not obtain stack trace; check that 'dbx' and 'sed' are installed and on your PATH
JnPocLocHierSK.LnChecksum_Sort,1: Failure during execution of operator logic.
Then it wasn't added or set correctly, it would seem. Can you double-check that it was added to the job and the value you set it to? Also, one of the first log messages should show all of the environment variables in play when the job runs, is it listed there?
-craig
"You can never have too many knives" -- Logan Nine Fingers
"You can never have too many knives" -- Logan Nine Fingers
This is very strange that the job ran for a few months and now error out with Chksum again...
$NTZ_DATA_SOURCE = NZSQL [$PROJDEF]
$APT_CONFIG_FILE = /opt/IBM/InformationServer/Server/Configurations/default.apt [$PROJDEF]
$APT_DISABLE_COMBINATION = True
Error:
Checksum,1: Internal Error: (!exportLog_->hasError()): checksum/checksum.C: 391
Traceback: Could not obtain stack trace; check that 'dbx' and 'sed' are installed and on your PATH
$NTZ_DATA_SOURCE = NZSQL [$PROJDEF]
$APT_CONFIG_FILE = /opt/IBM/InformationServer/Server/Configurations/default.apt [$PROJDEF]
$APT_DISABLE_COMBINATION = True
Error:
Checksum,1: Internal Error: (!exportLog_->hasError()): checksum/checksum.C: 391
Traceback: Could not obtain stack trace; check that 'dbx' and 'sed' are installed and on your PATH