Hi
Setting 'Continue' option for 'Condition Not met' clause is equivalent to setting no conditions. Correct ?
Or is there any use of this combination ?
thanks,
Sree
Look up - Condition Not met - Options
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
Re: Look up - Condition Not met - Options
No.sreelalpp wrote:Setting 'Continue' option for 'Condition Not met' clause is equivalent to setting no conditions. Correct ?
The default is Fail.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
As far my understanding, lookup will check the source data with lookup data and returns value to target... when you give a condition in the lookup, it will only check the source data which statisfies that condition and returns the lookup value and which doesnt satisfy that condition, it directly pass the source value to the target... if dont provide the condition, it checks all the source data with lookup data... This is the difference... So condion not met=Continue is not the same as without any condition....
Correct me if i'm wrong...
Correct me if i'm wrong...
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact: