Hi folks, I have a lookup stage doing nothing fancy. The stream link is set to SAME. The reference link is set to HASH. Both links have the preserve partitioning flag set to CLEAR.
I still get the warning.
Just for grins, I also cleared the flag on the lookup output.
Still get the warning.
Ideas? Does everybody just put these in a message handler? They provide no value as near as I can tell.
Thanks,
Doug
Cannot remove "will partition" warning
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
Clear the preserve partitioning flag on the stages upstream on the input links to the Lookup stage. Use Entire partitioning on the reference input link unless you can be 100% certain that the stream input link uses identical Hash partitioning propagated from upstream by Same.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Hi Ray, thanks. As I said, both links are set to CLEAR upstream. I also cleared the output link. I am certain the stream is partitioned by the ref link hash key. In any case, I will try using entire in case that helps.ray.wurlod wrote:Clear the preserve partitioning flag on the stages upstream on the input links to the Lookup stage. Use Entire partitioning on the reference input link unless you can be 100% certain that the stream input link uses identical Hash partitioning propagated from upstream by Same.
Any compelling reason not to demote this warning to info level across the entire project and just ignore the partitioning flag forever? It seems to be poorly implemented.