Hi,
I couldn't fine any "Debug" option in my menu to debug jobs.
I am having admin rights.
No Debug option for my DataStage?
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 21
- Joined: Tue Nov 02, 2010 2:36 pm
- Location: India
No Debug option for my DataStage?
Thank you,
Regards
Gowtham
(Learning DS)
Regards
Gowtham
(Learning DS)
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
Upgrade to version 8.5 to get a parallel job debugger.
Until then, you can change the job properties to compile in trace mode, and this will give you the ability to run a small number of rows per node and will automatically insert a peek operator on every link in the job.
Admin rights is not pertinent to this discussion.
Until then, you can change the job properties to compile in trace mode, and this will give you the ability to run a small number of rows per node and will automatically insert a peek operator on every link in the job.
Admin rights is not pertinent to this discussion.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
-
- Participant
- Posts: 21
- Joined: Tue Nov 02, 2010 2:36 pm
- Location: India
Thanks Ray... I was worried that, something wrong in the installation.
As of now, I cannot go for upgrade. I will use the trace options to debug as suggested for parallel jobs.
Ramesh -- You were saying that, we need to enable those variables. I did enable. But I don't see any changes or debug options in designer. Are you saying the same.?
If my understanding is wrong, please correct me.
Thanks lot for your reply.
As of now, I cannot go for upgrade. I will use the trace options to debug as suggested for parallel jobs.
Ramesh -- You were saying that, we need to enable those variables. I did enable. But I don't see any changes or debug options in designer. Are you saying the same.?
If my understanding is wrong, please correct me.
Thanks lot for your reply.
Thank you,
Regards
Gowtham
(Learning DS)
Regards
Gowtham
(Learning DS)