QS-STANDARDIZE job: received signal SIGSEGV

[n.parameswara.reddy@accen]

i have installed new server for quality stage, while running QS job its giving below SIGSEGV error

STANDARDIZE,0: Operator terminated abnormally: received signal SIGSEGV
STANDARDIZE,1: Operator terminated abnormally: received signal SIGSEGV
STANDARDIZE,2: Operator terminated abnormally: received signal SIGSEGV
STANDARDIZE,3: Operator terminated abnormally: received signal SIGSEGV

PLEASE HELP ME REGARDING THIS OPERATOR ISSUE.

THANKS IN ADVANCE
PARAM

[n.parameswara.reddy@accen]

i have installed new server for quality stage, while running QS job its giving below SIGSEGV error

STANDARDIZE,0: Operator terminated abnormally: received signal SIGSEGV
STANDARDIZE,1: Operator terminated abnormally: received signal SIGSEGV
STANDARDIZE,2: Operator terminated abnormally: received signal SIGSEGV
STANDARDIZE,3: Operator terminated abnormally: received signal SIGSEGV

PLEASE HELP ME REGARDING THIS OPERATOR ISSUE.

THANKS IN ADVANCE
PARAM

PLEASE HELP ME REGARDING THIS OPERATOR ISSUE

[ray.wurlod]

Learn patience (this is an all-volunteer site,and I'll bet even your official support provider doesn't guarantee a two hour response) and learn etiquette ("shouting" - that is, use of all upper case - is poor net etiquette). Both of these will limit people's willingness to help. Since it may be a QualityStage issue, it may have been more appropriate to post your question in the forum for QualityStage questions. Finally, have you searched DSXchange for something like SIGSEGV ? There are very many of them out there.