Hi
I have after routine , Exec Shell where I am try to concatenate 3 files.
When I concatenate these files using datastage after routine , there is no new line character when data between two line concatenate. So the data from new starts on the same line as old file data ends.
where as on command prompt when I actually run this command , new line character does appear.
Is there any special attention we need to give while writting command in after routine?
Shell command new line issue
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 3337
- Joined: Mon Jan 17, 2005 4:49 am
- Location: United Kingdom