viewlog

vinsashi · Post by **vinsashi** » Thu Feb 25, 2010 5:09 am

Hi,
my job compiled and run in designer.but in director if i see view log i am not getting anything page getting blank.any thing i have to enable i checked all but not getting

Thanks

chulett · Post by **chulett** » Thu Feb 25, 2010 6:21 am

Perhaps you're not looking at the correct log? It happens.

What happens if you run the job from Director?

vinsashi · Post by **vinsashi** » Thu Feb 25, 2010 6:35 am

it showing status if job success then it showing finished like that .if i click on viewlog then it showing blank

Thanks
....

chulett · Post by **chulett** » Thu Feb 25, 2010 6:38 am

And this is version 7, not 8, yes? And the job status changes like it should to Running and then some form of Finished? What do you see in the Monitor while it runs?

ray.wurlod · Post by **ray.wurlod** » Thu Feb 25, 2010 3:50 pm

Does the dsjob -logsum command work correctly?