Hi,
When I run a job on multiple node (windows 8x DS) and I do a normal lookup. The job aborts stating that lookup failed for the key records, but I see the data in the table when checked manually.
The lookup reference is in entire mode and the same job worked fine with more number of records.
Input to the lookup is 'Auto'. Input comes from a sequential file and Director log shows that only 10% of the file is read before the job is aborted. However, the lookup should have been successful.
Please pass on any suggestions.
Thanks,
Raviraj
Job running on Multiple node and lookup fails..
Moderators: chulett, rschirm, roy
Job running on Multiple node and lookup fails..
-----------------------
R-Square
[Ravi Raj]
R-Square
[Ravi Raj]
-
- Participant
- Posts: 3337
- Joined: Mon Jan 17, 2005 4:49 am
- Location: United Kingdom
-
- Participant
- Posts: 63
- Joined: Mon Oct 20, 2008 12:01 am
- Location: Malaysia
Job running on Multiple node and lookup fails..
Datatype, length, trim -everything was handled. Could not understand the issue.
-----------------------
R-Square
[Ravi Raj]
R-Square
[Ravi Raj]