Post questions here relative to DataStage Enterprise/PX Edition for such areas as Parallel job design, Parallel datasets, BuildOps, Wrappers, etc.
Moderators: chulett, rschirm, roy
-
satheesh.mohandass
- Participant
- Posts: 14
- Joined: Wed Dec 26, 2007 10:56 am
Post
by satheesh.mohandass »
My datastage server has NLS installed.
I would like to know if there is any way to disable NLS for a specific Project.
-
ArndW
- Participant
- Posts: 16318
- Joined: Tue Nov 16, 2004 9:08 am
- Location: Germany
-
Contact:
Post
by ArndW »
No, you cannot turn NLS on/off at a project level in DataStage.
-
Sreenivasulu
- Premium Member
- Posts: 892
- Joined: Thu Oct 16, 2003 5:18 am
Post
by Sreenivasulu »
NLS enabling requires re-install of datastage similarly NLS disabling requires re-install of datastage
Regards
Sreeni
-
ray.wurlod
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
-
Contact:
Post
by ray.wurlod »
Setting the project default map to NONE gets close to "disabling" NLS in the project.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
-
satheesh.mohandass
- Participant
- Posts: 14
- Joined: Wed Dec 26, 2007 10:56 am
Post
by satheesh.mohandass »
I tried to set the default map name ( Parallel Maps) to None from ISO-8859-1 and i got the below error.
FATAL ERROR (APT_CharsetConverterRep::initConv()): NONE is not a valid codepage.
-
ray.wurlod
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
-
Contact:
Post
by ray.wurlod »
OK, then try one of the simple ASCII maps.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.