Plug-in stage registration

dsedi · Post by **dsedi** » Thu Oct 23, 2008 11:58 am

Just to bringing back on top... Any help would be appreciated!

dsedi · Post by **dsedi** » Tue Oct 28, 2008 1:43 pm

No Luck..

.....Thanks looking!

ray.wurlod · Post by **ray.wurlod** » Tue Oct 28, 2008 1:44 pm

DLLs are sometimes tricky. Have you re-started the client machine in the meantime?

crouse · Post by **crouse** » Tue Oct 28, 2008 1:51 pm

See if you can see the stages in Designer in the Repository\StageTypes\Parallel\Processing.

If you can see it there, try dragging it onto a job design. If that works, you can also drag it over to a category on the Palette (where you'd usually see it)

-Craig

dsedi · Post by **dsedi** » Tue Oct 28, 2008 2:24 pm

ray.wurlod wrote:DLLs are sometimes tricky. Have you re-started the client machine in the meantime? ...

Yes Ray we did that couple of times...

dsedi · Post by **dsedi** » Tue Oct 28, 2008 2:26 pm

crouse wrote:See if you can see the stages in Designer in the Repository\StageTypes\Parallel\Processing.

If you can see it there, try dragging it onto a job design. If that works, you can also drag it over to a category on the Palette (where you'd usually see it)

-Craig

Yes Craig,As i have mentioned,we are able to see the stage in Designer in the Repository\StageTypes\Parallel\Processing.

But its Disabled-not able to use in the job design.

chulett · Post by **chulett** » Tue Oct 28, 2008 2:42 pm

Hmmm... are you able to use them in a Server job or not at all?