Post questions here relative to DataStage Enterprise/PX Edition for such areas as Parallel job design, Parallel datasets, BuildOps, Wrappers, etc.
Moderators: chulett , rschirm , roy
aditya
Charter Member
Posts: 41 Joined: Sat May 28, 2005 7:32 am
Post
by aditya » Thu Jul 24, 2008 12:20 pm
Hi all,
I have a Parallel job to read data from a dataset perform transformations and load the same into a DB2 Table.
However when I try to kick off the job from the DS Sequence I get the following error:
main_program: Fatal Error: Transfer does not have this output interface as its destination.
Message ID: IIS-DSEE-TFIC-00017
Any suggestions on where I could be going wrong.
Thanks
ray.wurlod
Participant
Posts: 54607 Joined: Wed Oct 23, 2002 10:52 pm
Location: Sydney, Australia
Contact:
Post
by ray.wurlod » Thu Jul 24, 2008 3:29 pm
Do you get the same error when running the job independently of the job sequence?
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
aditya
Charter Member
Posts: 41 Joined: Sat May 28, 2005 7:32 am
Post
by aditya » Thu Jul 24, 2008 3:36 pm
Ray,
Thanks for your quick repsonse, Yes I do get this error while I try to run the job independently.
chulett
Charter Member
Posts: 43085 Joined: Tue Nov 12, 2002 4:34 pm
Location: Denver, CO
Post
by chulett » Thu Jul 24, 2008 4:54 pm
Sorry if this is a silly question, but is "Transfer" the name of the job or a stage / link name within the job?
-craig
"You can never have too many knives" -- Logan Nine Fingers
Flyerman_2
Premium Member
Posts: 11 Joined: Mon Aug 17, 2009 9:42 am
Post
by Flyerman_2 » Thu Mar 25, 2010 7:26 am
I had the same problem: "Transfer does not have this output interface as its destination".
Now there is an IBM patch: fix JR31099.
By waiting its implementation, i found a temporary workaround: our project was with 6 nodes, i modify to have only one.
It is longer but now, it is running fine.