How to connect in Web Service client .

Hemant_Kulkarni · Post by **Hemant_Kulkarni** » Sat Jul 12, 2008 2:06 am

We are unable to connect to the web service client..and the following errors are getting...any help in this is appreciated.

main_program: Failed to initialize job monitoring. Monitor information will not be generated.

Xml_Currency,0: Error: The name '{0}' is not a valid NCName.
expression = '/:operJ06Response/operJ06Return/Serv_J06OutVar1' Remaining tokens are: ('/')

Webs_Currency,0: Error: The name '{0}' is not a valid NCName.
expression = '/:operJ06Response/operJ06Return/Serv_J06OutVar1' Remaining tokens are: ('/')

Xml_Currency,0: The runLocally() of the operator failed.
APT_CombinedOperatorController,0: Resource bundle corresponding to message key DSTAGE-TODC-00017 not found! Check that DSHOME or APT_RESPATH is set.

Regards
Hemant

chulett · Post by **chulett** » Sat Jul 12, 2008 6:23 am

Don't you think it might help a teensy bit if you explained how you are attempting to 'connect to the web service client' rather than making people guess or assume?

chulett · Post by **chulett** » Mon Jul 14, 2008 7:32 am

All - this has been reposted in the proper forum and should be responded to there. Thanks.

Hemant_Kulkarni · Post by **Hemant_Kulkarni** » Thu Jul 17, 2008 2:28 am

Dear All,

Could you please anybody help me on this issue.

Thanks & Regards
Rao

eostic · Post by **eostic** » Thu Jul 17, 2008 5:16 am

I believe this was already responded to in the RTI forum?

Ernie

chulett · Post by **chulett** » Thu Jul 17, 2008 6:30 am

Yes.