Sequencer job actvy parameters missing after successful run

verify · Post by **verify** » Wed Jun 04, 2008 4:49 am

Hi,

We are facing a peculiar problem with sequencers. The issue is that for some job activities the parameters go missing even after a successful run of the sequencer. The sequencer goes into Uncompiled state. Is this a bug in 8.0.

Thanks,
Prasanna

ArndW · Post by **ArndW** » Wed Jun 04, 2008 5:05 am

We have encountered issues with Parameter Sets at V8 to which we received a client-side patch; but we never saw the "uncompiled" state problem.

verify · Post by **verify** » Wed Jun 04, 2008 6:37 am

ArndW wrote:We have encountered issues with Parameter Sets at V8 to which we received a client-side patch; but we never saw the "uncompiled" state problem.

Hi ArndW,

Thanks for the response.We are actually using a list of parameters and not a parameter set. Can you please elaborate the issue faced.Please let me know if the patch is applicable to parameters too.

Thanks

ArndW · Post by **ArndW** » Wed Jun 04, 2008 7:11 am

The patch we needed was only applicable to V8 Parameter Sets and does not apply to normal parameters.