Hi All,
I made a small change in the shared container and recompiled what job using that shared container.But I am trying to run the job it is again asking to recompile job like this going on every time.When I closed the data stage session and open the new session then it is not asking for compilation.
what is the problem here I cont find out can any one face like this before please guide me to resolve the same.
Thanks in advance,
Praveen.
shared container problem
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 106
- Joined: Wed Oct 04, 2006 5:21 am
Re: shared container problem
When it asks you to recompile it usually gives a reason, what is that? Also, are you using one designer instance for both the job and shared container?thumati.praveen wrote:...But I am trying to run the job it is again asking to recompile job like this going on every time...
<a href=http://www.worldcommunitygrid.org/team/ ... TZ9H4CGVP1 target="WCGWin">
</a>
</a>
-
- Participant
- Posts: 106
- Joined: Wed Oct 04, 2006 5:21 am
Re: shared container problem
Reason is the job reference shared container(s) chaged you must recompile the job.ArndW wrote:When it asks you to recompile it usually gives a reason, what is that? Also, are you using one designer instance for both the job and shared container?thumati.praveen wrote:...But I am trying to run the job it is again asking to recompile job like this going on every time...
First I changed the shared container and I saved and closed the shared container then I compile the reference job and I tried to run but it is asking again to recompile the job.
thanks,
Praveen.
This is because shared containers are actually loaded and compiled into a job at compile time.
<a href=http://www.worldcommunitygrid.org/team/ ... TZ9H4CGVP1 target="WCGWin">
</a>
</a>
-
- Participant
- Posts: 106
- Joined: Wed Oct 04, 2006 5:21 am
If you edit your job, open and edit the shared container in the job, then save the shared container and save the job you will only be asked to compile 1 time in the designer.
<a href=http://www.worldcommunitygrid.org/team/ ... TZ9H4CGVP1 target="WCGWin">
</a>
</a>
-
- Participant
- Posts: 106
- Joined: Wed Oct 04, 2006 5:21 am
I was opend the sahred container direct from repository and I made changes and saved.If we will do in this it will give problem or what?ArndW wrote:If you edit your job, open and edit the shared container in the job, then save the shared container and save the job you will only be asked to compile 1 time in the designer. ...