Hi,
I am writing the Datasets in sequential mode. But when I am reading the dataset in the next job in parallel mode, I am not able to read it and it remains halt after some time.
Could anyone faced this problem earlier?
Regards,
pksahu
Problem in Dataset Reading
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
Are any error messages produced? Do both jobs (the one that writes data into the Data Set and the one that reads from the Data Set) use the same configuration file? Can you view the data in the Data Set using the Data Set Management tool?
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
-
- Participant
- Posts: 29
- Joined: Mon Nov 20, 2006 7:17 am
- Location: Melbourne
-
- Premium Member
- Posts: 783
- Joined: Mon Jan 16, 2006 10:17 pm
- Location: Sydney, Australia