Hi ,
While calling a Quality stage job using the command execute stage in a sequencer, it gives a warning and fails. While using the telnet i am able to run the QS job successfully.
I use the sh 2>&1 and pass its parameters.
Its says reply=1 and at the end I see a "Op Failed osh (1)"
Any ideas pls?
calling a Quality stage job from the sequencer
Moderators: chulett, rschirm, roy
calling a Quality stage job from the sequencer
Regards,
Madhu Dharmapuri
Madhu Dharmapuri
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
It's "sequence", not "sequencer". Job exit status is 0 = running, 1 = finished OK, 2 = finished with warnings, etc. You need to create a custom trigger on the Execute Command activity so that it does not assume that a non-zero exit status is automatically a failure.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact: