Hi all,
Is it possible to write a config file which has two nodes and each node pertains to two different servers.. that is
if i have two servers S1 and S2 .. can i write a config file ABC with nodes N1 and N2 .. where N1 has procesing power of and uses disk storage of S1 and N2 and processing power and uses disk strorage of S2
hope its made sence ..
cheerz
Node configuration
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
Absolutely. What you are describing is an MPP configuration (read about this in the Manager Guide - the chapter on Configurations).
You will need to make sure that certain executables/libararies are available on all nodes.
Code: Select all
/* Two nodes, two machines */
{
node "N1"
{
fastname "S1"
...
}
node "N2"
{
fastname "S2"
...
}
}
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.