Not showing up link count

bucks · Post by **bucks** » Tue May 08, 2007 1:07 pm

Hi All,

The jobs has sucessfully finished and we could see the log in director saying it imported x rows from the seq file. but in designer was not able to see any link count in the perfomance statistics.

Please suggest some suggestions on this.

thanks in advance

mctny · Post by **mctny** » Tue May 08, 2007 1:50 pm

Did you save or compile the job after you run?

bucks · Post by **bucks** » Tue May 08, 2007 2:51 pm

No i didnt do that.

thanks

nick.bond · Post by **nick.bond** » Tue May 08, 2007 4:14 pm

Check whether APT_NO_JOBMON has been set.

ray.wurlod · Post by **ray.wurlod** » Tue May 08, 2007 5:09 pm

Or even whether the job monitor application (JobMonApp) is running.

vmcburney · Post by **vmcburney** » Tue May 08, 2007 6:15 pm

Or that it didn't reject all the rows due to metadata mismatch. You got a reject link on that sequential file stage?

csrazdan · Post by **csrazdan** » Wed May 09, 2007 2:36 pm

Open job in Designer.
On Job canvas right click. Is "show perfomance statistics" checked.
If not check it and it should show link counts.

Hope it helps...