Hi,
I am writing a routine. Job sequencer name I am passing as a parameter. I need to get list of job names that are calling in a particular sequencer. Can anybody please help me out, is there any option in DS to get the list of job names from the sequencer or else is there any other solution.
Thanks in advance.
Getting job names from a sequencer.
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
This has been discussed previously. You could search for those answers.
The big question is whether you want a list of the jobs designed in Job activities in the job sequence (note, not "sequencer", which is a component in a job sequence), or whether you want the jobs that were actually invoked.
It is possible only to run some of the jobs in a job sequence, perhaps because of failure, perhaps because of the job sequence's own logic, perhaps because it's restarting.
Obviously the technique will differ in the two scenarios.
The big question is whether you want a list of the jobs designed in Job activities in the job sequence (note, not "sequencer", which is a component in a job sequence), or whether you want the jobs that were actually invoked.
It is possible only to run some of the jobs in a job sequence, perhaps because of failure, perhaps because of the job sequence's own logic, perhaps because it's restarting.
Obviously the technique will differ in the two scenarios.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact: