Hi all,
I am trying to use change capture in my job,i have connected two datasets to change capture and one dataset as output but the problem is i am gettin an warning like this can u just give me a solution
Warnning Message: Change_Capture_11: When checking operator: Defaulting "AccountType" in transfer from "beforeRec" to "outputRec".
Please respond to this.......
Regards,
N.Magesh
change capture in parallel jobs
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 153
- Joined: Thu May 11, 2006 1:52 am
- Location: Bangalore
-
- Premium Member
- Posts: 397
- Joined: Wed Apr 12, 2006 2:28 pm
- Location: Tennesse
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
It (RPC) may be disabled for the entire project which, to my mind, is a Good Thing.
The error message (which you only posted part of) suggests incomplete mapping to the output link. Go there, and check the Mapping tab.
The error message (which you only posted part of) suggests incomplete mapping to the output link. Go there, and check the Mapping tab.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
-
- Participant
- Posts: 222
- Joined: Tue Aug 30, 2005 2:07 am
- Location: pune
- Contact:
Hi,
Disable RCP option at the job level in the property tab. Where you can find option called Enable runtime column propogation for new links. Don't select that option that means nothing but Disabled.
Disable RCP option at the job level in the property tab. Where you can find option called Enable runtime column propogation for new links. Don't select that option that means nothing but Disabled.
NageshSunkoji
If you know anything SHARE it.............
If you Don't know anything LEARN it...............
If you know anything SHARE it.............
If you Don't know anything LEARN it...............
-
- Premium Member
- Posts: 397
- Joined: Wed Apr 12, 2006 2:28 pm
- Location: Tennesse
-
- Participant
- Posts: 222
- Joined: Tue Aug 30, 2005 2:07 am
- Location: pune
- Contact:
Hi,samsuf2002 wrote:where can we find the option to enable/disable RCP i dont find in CDC stage can any one please help me out
Thanks
You can find the Run time column propogation at the stage level also, In Change Capture stage-go to the output tab and then go to the Columns tab, in that tab see below the cloumns at the left corner, where you can find the Runtime column propogation, if you want enable select the box and disable don't select the box. Default is enable.
NageshSunkoji
If you know anything SHARE it.............
If you Don't know anything LEARN it...............
If you know anything SHARE it.............
If you Don't know anything LEARN it...............