I am running a parallel job "X" from a sequence "SEQ1". This sequence (SEQ1) is needed to run from another sequence (SEQ2). This SEQ1 is a common sequence need to run 11 times in SEQ2.
I enabled "allow multiple instance" check box in the job properties to the SEQ1 in the job properties. So when i dragged into the SEQ2, it is getting its own invocation id with its link name which is connecting to it.
I also enabled "allow multiple instances" check box in the job "X" as well.
When iam running job "X" indenpendently it is running fine. And also when i run SEQ1 indenpendently with the job "X" in it, it is running fine too..
But, When is run the SEQ1 in SEQ2, ----SEQ1 is getting aborted, this is getting aborted because of the job "X".
Below is the error message that i captured form the director:
SEQ1.Invocationid.JobControl (@X): Controller problem: Error calling DSRunJob(X), code=-2
[Job is not in the right state (compiled and not running)]
Some times, while iam testing the SEQ2, Job "X" is getting locked.
Any suggesstions??
![Sad :(](./images/smilies/icon_sad.gif)