Error running sequence

bala_135 · Post by **bala_135** » Fri Jul 07, 2006 11:06 pm

Hi,

When i run the sequence i am having a error.
My os is Windows XP.anyting can be done to solve this.
I am not getting any error for other jobs.
main_program: **** Parallel startup failed ****
This is usually due to a configuration error, such as
not having the Orchestrate install directory properly
mounted on all nodes, rsh permissions not correctly
set (via /etc/hosts.equiv or .rhosts), or running from
a directory that is not mounted on all nodes. Look for
error messages in the preceding output.

Regards,
Bala.

ArndW · Post by **ArndW** » Sat Jul 08, 2006 3:25 am

The error is not in your sequence, but in one the PX jobs which it calls. Can you isolate that job? Can you run any PX jobs at all? If not, then the error message is most likely accurate and you need to look at the setup on your remote (presumably the database) machine. Can you rsh as that user to the nodes defined in your APT_CONFIG file?

ray.wurlod · Post by **ray.wurlod** » Sat Jul 08, 2006 6:38 am

What exact version of DataStage are you using? Unless it is 7.5x2 you can not expect any success at all. Even that version is not officially supported on Windows XP as the server. Do you have the DataStage patch needed for XP service pack 2?

bala_135 · Post by **bala_135** » Mon Jul 10, 2006 5:44 am

Hi Ray,

Its 7.5.2.

Regards,
Bala.

ray.wurlod · Post by **ray.wurlod** » Mon Jul 10, 2006 5:51 am

This is not the same as 7.5x2. Check with your vendor or support provider.

Krazykoolrohit · Post by **Krazykoolrohit** » Mon Jul 10, 2006 8:31 am

Do you see any warnings pointing to a particular job?

bala_135 · Post by **bala_135** » Wed Jul 12, 2006 4:09 am

No Only Error Message.

Regards,
Bala.