Hi,
We have a problem here which started couple of days earlier. We have scheduled our jobs through Tivoli workflow Manager but lately we notice that the jobs fail to fire .
We have tried to fire jobs from Director/Disigner but some times it happens that the jobs does not reponds to the run button.
What might be the cause of the problem, this happens with any of the job.
What do you mean not respond? No effect at all. What about through the command line? When you go into the dirctor, whats the jobstatus there? Any funny log file messages?
Creativity is allowing yourself to make mistakes. Art is knowing which ones to keep.
If it isn't, then your job is not in a runnable state. Status view in Director should indicate whether this is the case. In Log view you will be able to see whether it starts and stops, or fails to start at all.
Research that and let us know the result.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Let me answer one by one:
Clicking on the button doesn't effect.
Status on Director shows the Run button enable all the time
In Log view the we could only find the log of last run log.
No Funny log messages.
What is the actual status of the job, as reported by Director? (For example, the behaviour you describe would occur if the status were "Not Compiled".)
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
need to know the job status from the director. Also in your designer, try running it via the keyboard, i think its F9. You can check the shortcut by going to File.
Do all the developers at your end face this issue?
Creativity is allowing yourself to make mistakes. Art is knowing which ones to keep.
Yes we have tried firing it through keyboard but again the job wont run, the status would be still runnable (run button is enabled).
The funny thing is it runs from command line from server.
The funny thing is it runs from command line from server.
Do you mean to say only from server machine and not even in any of your client machine. How do you call from Tivoli workflow Manager, is it same as the command used to call from server?
Impossible doesn't mean 'it is not possible' actually means... 'NOBODY HAS DONE IT SO FAR'
Have you tried running the same shell script from server command prompt?
Try to run the dsjob comand from the client command prompt directly?
But you are sure about compiling from client isnt a issue?
Impossible doesn't mean 'it is not possible' actually means... 'NOBODY HAS DONE IT SO FAR'
Yes, I have tried all types of method even try running shell script from server which runs fine too. The only thing left is I should try running from client command propmt.
I'll post my results then.