DSXchange

When I executed a parallel job it was sucessfully.
But when I try to run it in sequencer it gave a fatal error like "main_program :ORCHESTRATE step execution terminating due to SIGINT"
Even deleted all input and output dataset but still getting same error. Any solution???

(Post topic edited by Roy)

Hi,
I assume you run the parallel job from the designer
and running with no limit to warnings

when you run it from a sequence it probably hit the default 50 warnings limit

Please check and confirm if this is the case

P.S.
I'll edit the post topic, since the current one is not describing the issue.

IHTH (I Hope This Helps),

Hi,

Is job is having lot of warning messages?

Have you executed sequence in no limit option mode.

As others have noted, please check the job log of the sequence job. Report back the detail of the first Fatal message. Also report back the content of the first Fatal mesage in the log of the job itself when run under control of the sequence.

I ran the job and seq in no limit to warnings only but still getting same error.

Please check the job log of the sequence job. Report back the detail of the first Fatal message. Also report back the content of the first Fatal mesage in the log of the job itself when run under control of the sequence.