Job sequence finished with Warning
Posted: Wed Nov 25, 2015 5:00 pm
Hi All,
We have a Datastage job sequence which is scheduled to run every hour through Control-M.
The job is running successfully without any issues but the sequence throws a warning message Job EX12_OPTED_OUT_SEQ must be reset before it can run.
The warning happens to be occurring very random.
I do have a setting in my sequence to Reset if required, then run.
I tried to search the forum for relevant issues but couldn't find any.
Can anyone shed some light on this.
Regards
Coles
We have a Datastage job sequence which is scheduled to run every hour through Control-M.
The job is running successfully without any issues but the sequence throws a warning message Job EX12_OPTED_OUT_SEQ must be reset before it can run.
The warning happens to be occurring very random.
I do have a setting in my sequence to Reset if required, then run.
I tried to search the forum for relevant issues but couldn't find any.
Can anyone shed some light on this.
Regards
Coles