Hi All,
We have a Datastage job sequence which is scheduled to run every hour through Control-M.
The job is running successfully without any issues but the sequence throws a warning message Job EX12_OPTED_OUT_SEQ must be reset before it can run.
The warning happens to be occurring very random.
I do have a setting in my sequence to Reset if required, then run.
I tried to search the forum for relevant issues but couldn't find any.
Can anyone shed some light on this.
Regards
Coles
Job sequence finished with Warning
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 36
- Joined: Thu Dec 03, 2009 9:11 pm
- Location: Malaysia
Re: Job sequence finished with Warning
Hi ,
Did you check after setting the sequence to "reset if required and then run" enabled.
Even after that the problem persist let me know.
Regards
Naveen
Did you check after setting the sequence to "reset if required and then run" enabled.
Even after that the problem persist let me know.
Regards
Naveen
Naveen Kumar
Datastage Consultant
Datastage Consultant
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
Welcome aboard.
What error message(s) occur in the sequence's log when this error occurs?
What exit status was returned to, and processed by, Control-M in this case?
Please post exact error messages.
What error message(s) occur in the sequence's log when this error occurs?
What exit status was returned to, and processed by, Control-M in this case?
Please post exact error messages.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.