Page 1 of 1
Change default port
Posted: Thu Jan 15, 2015 5:25 am
by jerome_rajan
Hi,
Is there a way to change the default port from 31538 to 31539? If yes, how?
Thank you
Posted: Thu Jan 15, 2015 6:06 am
by ArndW
I don't think it is practicable to do so after installation rather than as part of the installation process. Back in the day when DataStage was less complicated I might have been able to recommend the changes in good confidence that it would work, but at 9x or higher I would never be sure that I found all of the places where the port might have been encoded.
Posted: Tue Jan 20, 2015 9:45 am
by qt_ky
It is probably possible. Contact Support to request a procedure.