Not able to restart sequence job
Posted: Wed Dec 15, 2010 9:35 am
Hi all,
I have created one sequence with all necessary settings to make it restartable.
My sequence design look like:
When I compile it, it again start from seq1.
What am I missing here? What should I do so that after restart my sequence run from Seq2?
Any help will be much appreciated.
I have created one sequence with all necessary settings to make it restartable.
My sequence design look like:
When my Seq2 aborts then it shows status as aborted/restartable. But when I restart it I get following message "sequence is not in runnable state"Seq1--->Seq2
When I compile it, it again start from seq1.
What am I missing here? What should I do so that after restart my sequence run from Seq2?
Any help will be much appreciated.