DSXchange

Hi,

I am using parameter sets in my job and they run fine. When i replace the I/p and O/P files with WISD I/P and O/P i am getting a problem.

As a practice i create a service/operation and point the service to the job the Information server console throws a error saying

"Error trying to create a reference provider "

com.ascential.rti.design.QueryFailedException: A query failed with the following message: 'Could not open parameter "Informix_Parameters" of job "test".'

Not sure what might be wrong.

Can we refer to parameter sets for a webservice ?

Kindly guide me through this process.

Thanks a Lot

Found that Parametersets do not work on using stored procedures as well.
So i think you should use normal job parameters in those cases

Regards
Sreeni

Did either of you open a case with your official support provider, get an official verdict on the problem?