Page 1 of 1
Datastage TX 7.5.0 Card Editing
Posted: Fri Jul 10, 2009 10:43 am
by manniej
Hi. I'm new to this forums and hoping that somebody can help me in my problem with using Datastage TX 7.5. When I do change input file setting and save, the setting is not really being saved. I rebuild, save and reran the map but the input source file is still the previous file. Is there something on this application that I need to setup? Thanks for any help.
Posted: Fri Jul 10, 2009 11:33 am
by chulett
There is a specific forum for TX questions and the people that answer them really only check that forum, I do believe. So I'd suggest you mark this one as Resolved and repost it over there. Sorry.
Posted: Fri Jul 10, 2009 12:01 pm
by manniej
Sorry I didn't know there's a specific forum for this subject. I thought This is the forum to discuss about Datastage TX. As I mentioned before, I'm new to this forum and would greatly appreciate if you can point me to the name of the correct forum. Thanks.
mannie
Posted: Fri Jul 10, 2009 12:21 pm
by chulett
Sorry, figured it would be obvious to you once I pointed that out - it's the one named
IBM DataStage TX (scroll down to see it) but here's a direct link to it:
viewforum.php?f=43
Posted: Fri Jul 10, 2009 12:48 pm
by manniej
Got it! Thanks.