DSXchange

I modified a standardization QStage job. Added two extra columns to be o. When I run the QS job it runs as expected. However, when I run the sequencer that calls the QStage job. I get the error below. The sequencer didn't change but I recompiled it just in case.

Sqnc1DailyHHStgExt..JobControl (@QS_STANALL): Executed: /edw/di/ext/Edw1Dev/script/ExQsJobs HHDAILY STANALL
Reply=0
Output from command ====>
stty: tcgetattr: A specified file does not support the ioctl system call.
ERROR: osh is unavailable. Please install or configure

Op Failed osh (1)
/edw/di/proj/Edw1Dev

Posting the same question in multiple forums is annoying and wastes our time. Please refrain from doing so.

ray.wurlod wrote:Posting the same question in multiple forums is annoying and wastes our time. Please refrain from doing so.

My apologies. I was trying to get it in the proper place. Thanks for letting me know of your angst.

FYI - a good angst reliever, once you've discovered your mistake and copied the post into the correct forum, is to go back and delete the errant ones. You are allowed to do this with anything you post (topic starter or reply) as long as there are not replies to it.