Hi ,
How can I abort a job when it throws a warning . I know we can set the warn limit to 1 . But i dont know how to set it when I run the job thru sequence.Is it a job level setting .
Or is there any other work around .
abort job in a single warning
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
Doesn't Search work on your computer?
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Hi Shrini,
For this just go to the director where your sequence job is, click on it and then to "Tools" menu in the toolbar. Drop it down and you will see "options" in it.In the "General" tab you can see "Rows" and "Warnings" having radio buttons on it. Select "Abort Job after" and set Warnings to 1. This will help in aborting job after one warning.
Try this that you got it or not.
For this just go to the director where your sequence job is, click on it and then to "Tools" menu in the toolbar. Drop it down and you will see "options" in it.In the "General" tab you can see "Rows" and "Warnings" having radio buttons on it. Select "Abort Job after" and set Warnings to 1. This will help in aborting job after one warning.
Try this that you got it or not.
Sufiyan