My installation always worked very well, from a few days to here DataStage Designer opens the job, I can open some stage, I edit that and when I give ok to compile the datastage it close and the job stay lock.
Has anyone had this problem?
I already uninstall and re-install and it did'nt fix the problem.
Regards,
Fernando
Datastage closes all the time
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 142
- Joined: Wed Mar 24, 2004 10:51 am
- Location: Brazil
Any idea what changed to make this start, O/S patches perhaps? Another suspect might be anti-virus. But I would think in either case a re-install would get you back on track. I would try it one more time but this time nuke it from orbit, it's the only way to be certain.
Specifically:
1. Uninstall the client
2. Remove any remnants of the install directory from your hard drive
3. Use regedit to remove the entire hive / set of entries for DataStage from your registry
4. Reboot
5. Re-install the client
Sometimes that is what it takes. If you're not familiar with regedit and the Windows registry, get some help with that step.
Specifically:
1. Uninstall the client
2. Remove any remnants of the install directory from your hard drive
3. Use regedit to remove the entire hive / set of entries for DataStage from your registry
4. Reboot
5. Re-install the client
Sometimes that is what it takes. If you're not familiar with regedit and the Windows registry, get some help with that step.
-craig
"You can never have too many knives" -- Logan Nine Fingers
"You can never have too many knives" -- Logan Nine Fingers
-
- Participant
- Posts: 142
- Joined: Wed Mar 24, 2004 10:51 am
- Location: Brazil
Fixed, thanks!chulett wrote:Any idea what changed to make this start, O/S patches perhaps? Another suspect might be anti-virus. But I would think in either case a re-install would get you back on track. I would try it one more time but this time nuke it from orbit, it's the only way to be certain.
Specifically:
1. Uninstall the client
2. Remove any remnants of the install directory from your hard drive
3. Use regedit to remove the entire hive / set of entries for DataStage from your registry
4. Reboot
5. Re-install the client
Sometimes that is what it takes. If you're not familiar with regedit and the Windows registry, get some help with that step.