Hi Folks,
We are facing a issue where we are unable to run any of the jobs from designer nor director.
When tried running jobs it does nothing. We checked in director the status was showing only compiled status but the job actually did not run. Not sure whats the issue. Can any one share your thoughts.
Thanks
Unable to run the datastage jobs
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 36
- Joined: Thu Dec 03, 2009 9:11 pm
- Location: Malaysia
Re: Unable to run the datastage jobs
hi ,
you have to be more specific on whats happening.
What do you mean by when you are trying to run the job, are you speaking about you clicked the run button and it does nothing? Is that what you mean ..btw ..did you try to execute it through dsjob command ???
Regards
Naveen
you have to be more specific on whats happening.
What do you mean by when you are trying to run the job, are you speaking about you clicked the run button and it does nothing? Is that what you mean ..btw ..did you try to execute it through dsjob command ???
Regards
Naveen
Naveen Kumar
Datastage Consultant
Datastage Consultant
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
Perhaps it's the buttons in the tools. Try running from the menu. If this works, close the Designer and Director windows (ideally re-boot the client machine) and start with newly-opened clients.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.