Hi All,
In one of master sequence i have 6 Sub sequence.
Some time when sub sequence fails and get restarted it is throwing a warning "The current job run does not have the same parameters as its checkpoint record."
This warning goes off when i re run master sequence.
Could any one please suggest me what corrective step to stop this warning message.
Will it works if i check "Do not checkpoint run" , because i do not require a check point. for every run sequence should get fresh start.
Thanks.
Warning "The current job run does not have the same par
Moderators: chulett, rschirm, roy
This warning is pretty straight forward. It's just telling you that the restart run is using different parameter values than the original run. The first entry of a job log will tell you what parameter values are being used in a run.
To eliminate the warning make sure the restart run uses the same values as the original run.
Mike
To eliminate the warning make sure the restart run uses the same values as the original run.
Mike