Job stay in running mode in director
Moderators: chulett, rschirm, roy
Job stay in running mode in director
Hi gurus
We are facing the following issue: some jobs are staying "running" in the Director.
When we check the monitor all the stages are green and in the log we can see the sequence main program finished "Ok".
On the server a process usvh is present.
What is your advice?
Thank you.
We are facing the following issue: some jobs are staying "running" in the Director.
When we check the monitor all the stages are green and in the log we can see the sequence main program finished "Ok".
On the server a process usvh is present.
What is your advice?
Thank you.
Hope This Helps
Regards
Regards
Happens from time to time. Check out this technote and see if it helps clear up the issue.
http://www-01.ibm.com/support/docview.w ... wg21390366
http://www-01.ibm.com/support/docview.w ... wg21390366
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
I'd still look at the &PH& directory in the project and see if it has "a large number" of entries in it. And when you are at a point where no jobs are (legitimately) running in it, do the CLEAR.FILE mentioned. Keeping it pruned down - assuming there are many files there - is actually one way to avoid problems.
-craig
"You can never have too many knives" -- Logan Nine Fingers
"You can never have too many knives" -- Logan Nine Fingers
Create a "CopyOf" job, rename the orriginal to "..._bak", rename the CopyOf to the orriginal name, recompile.
See if the issue persists. If it does not, then you can analyze your "_bak" files. If it does, then you have a larger environmental issue and this freeze might be affecting other jobs, but you just don't know it yet.
Do you have any After Job routines on this job that could still be running?
See if the issue persists. If it does not, then you can analyze your "_bak" files. If it does, then you have a larger environmental issue and this freeze might be affecting other jobs, but you just don't know it yet.
Do you have any After Job routines on this job that could still be running?