Hello,
I have a required where I need to assign the environment variable into local variable..
For e.g.
Environment Variable
$NM_USER=U1
$NM_USER1=U2
In Master Sequncer I have one variable USER. Based on the condition I want to read the value as
USER=$NM_USER or USER=$NM_USER. The output should be Either U1 or U4, Please advise how can I get it done.
I tried the above mentioned point and the output I am getting is $NM_USER not U1.
Regards
Neeraj
Reading Envrironment Variable in Local Variable
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
This may not help you, but Job Activity stage on the job sequence pallate gives you the same derivation functions found in the Transformer stage. You can assign to a local variable any value you want, including environment variables listed in the job sequence properties parameters.
Franklin Evans
"Shared pain is lessened, shared joy increased. Thus do we refute entropy." -- Spider Robinson
Using mainframe data FAQ: viewtopic.php?t=143596 Using CFF FAQ: viewtopic.php?t=157872
"Shared pain is lessened, shared joy increased. Thus do we refute entropy." -- Spider Robinson
Using mainframe data FAQ: viewtopic.php?t=143596 Using CFF FAQ: viewtopic.php?t=157872