Hello
Our current process is collecting the dsjob -run output and storing it in the database. But, it doesnt give the entire log that i see in the director.
I do know that i can do a dsjob -logdetail to get the detailed log. But is it possible to run the datastage job and output with a single command?
Thank you.
Run datastage job and print complete log with one command
Moderators: chulett, rschirm, roy
-
ray.wurlod
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
Welcome aboard.
How about dsjob -logsum (summary)? There is no single command that will get you the full detail of the entire log, in much the same way and for the same reason that you cannot do it in Director.
How about dsjob -logsum (summary)? There is no single command that will get you the full detail of the entire log, in much the same way and for the same reason that you cannot do it in Director.
Last edited by ray.wurlod on Tue Feb 05, 2013 12:02 am, edited 2 times in total.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
