Hi,
I have a sequence job that runs simultaneously 2 instances of the same job (after a sequencer).
The log contains the following lines :
RunJob <Seq_Job> -> (<ParallelJob.Instance1>): Job run requested (...)
Info <Seq_Job.Instance.JobControl> (DSRunJob): Waiting for job <ParallelJob.Instance1> to start
RunJob <Seq_Job> -> (<ParallelJob.Instance2>): Job run requested (...)
Info <Seq_Job.Instance.JobControl> (DSRunJob): Waiting for job <ParallelJob.Instance2> to start
Info <Seq_Job.Instance.JobControl> (DSWaitForJob): Waiting for job <ParallelJob.Instance2>+<ParallelJob.Instance1> to finish
Info <Seq_Job.Instance.JobControl> (DSWaitForJob): Job <ParallelJob.Instance2> has finished, status = 3 (Aborted)
Warning <Seq_Job.Instance.JobControl> (<@LinkToParallelInstance2>): Job <ParallelJob.Instance2> did not finish OK, status='Aborted'
Warning <Seq_Job.Instance.JobControl> (<@LinkToParallelInstance2>): Controller problem: Unhandled abort encountered in job <ParallelJob.Instance2>
Info <Seq_Job.Instance.JobControl> (DSWaitForJob): Waiting for job <ParallelJob.Instance1> to finish
Info <Seq_Job.Instance.JobControl> (DSWaitForJob): Job <ParallelJob.Instance1> has finished, status = 1 (Finished OK)
Info <Seq_Job.Instance.JobControl> (@Coordinator): Summary of sequence run (...)
Fatal <Seq_Job.Instance.JobControl> (fatal error from @Coordinator): Sequence job will be aborted due to previous unrecoverable errors
No log is produced for <ParallelJob.Instance1>, nor for <ParallelJob.Instance2> (even if the log "says" that <ParallelJob.Instance1> has been started and terminated OK.
Does anyone have any idea about what is happening ?
Strange termination of Sequence job
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
What are your Auto-Purge settings for "ParallelJob"? Where are your logs stored - are you using ORLogging or RTLogging?
Last edited by chulett on Fri Aug 24, 2012 3:37 pm, edited 1 time in total.
-craig
"You can never have too many knives" -- Logan Nine Fingers
"You can never have too many knives" -- Logan Nine Fingers
Can't answer that question. Did you perhaps change the logging from one location to the other and what you are seeing are pre- or post-change? Or is it set differently per project? Perhaps it is specific to your version, something you haven't mentioned yet.
You'd really need to put that in front of your official support provider to find out what's going on, it would seem to me.
You'd really need to put that in front of your official support provider to find out what's going on, it would seem to me.
-craig
"You can never have too many knives" -- Logan Nine Fingers
"You can never have too many knives" -- Logan Nine Fingers