export routines via command prompt

Suruchi · Post by **Suruchi** » Tue Feb 07, 2012 4:25 am

Hi could anybody tell me the command prompt to export routines.
i tried dsexport.exe <host> <user> <password> <jobname> <targetpath/jobname.dsx>

It exports datastage jobs but i wanted to do the same for routines as well.
thanks in advance

PhilHibbs · Post by **PhilHibbs** » Tue Feb 07, 2012 5:18 pm

Suruchi wrote:Hi could anybody tell me the command prompt to export routines.

I don't think there is such a thing. You would have to do a full dsexport and then pull the dsroutines section out of that.

chulett · Post by **chulett** » Tue Feb 07, 2012 5:20 pm

You've asked this question more than once and gotten the same answer each time... not sure why you feel the need to keep asking it.

Suruchi · Post by **Suruchi** » Wed Feb 08, 2012 1:51 am

Thanks for your reply guys. Is there any means to send a message to IBM so that they can fix this. And please refer to this link. they have mentioned of exporting routines http://www-01.ibm.com/support/docview.w ... wg1JR31326

@chullet
I was not sure that this message has been posted. Hence did it twice unknowingly

chulett · Post by **chulett** » Wed Feb 08, 2012 8:05 am

Contact your official support provider.

DSXchange

export routines via command prompt

export routines via command prompt

Re: export routines via command prompt