Hi,
Which stages allow field names to be specified using job parameters?
Or maybe rather, which can't?
thanks
Stages, field names and job parameters
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
Thanks a lot for the answers.
I tried to find the answer myself. E.g., I read the coredevgde.pdf, ie, Designer Guide, but only to find:
Where can I read about where exactly the Job Parameters can be used in Parallel Jobs?
thanks
I tried to find the answer myself. E.g., I read the coredevgde.pdf, ie, Designer Guide, but only to find:
but nothing specific where and how to use them. So,Using Job Parameters in Parallel Jobs
You can use the defined parameters by specifying them in place of
properties in a parallel job stage editor. ...
Where can I read about where exactly the Job Parameters can be used in Parallel Jobs?
thanks
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
Properties are usually to be found in the properties tab for the stage (not the Columns tab). There are some exceptions, such as the Format tab in the Sequential File stage, and non-standard stage editors such as Lookup and Transformer stages.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.